Actron CP OBD II AutoScanner • User guide • Download PDF for free and without registration!. For more information regarding DTC updates, please call our Technical. Support line at ( – EST Monday – Friday), or. send an email to. Although the Actron CP is no longer in production, it is still a widely Refer to the vehicle’s owner’s manual for the location of the DLC, if necessary.
|Published (Last):||4 September 2008|
|PDF File Size:||1.51 Mb|
|ePub File Size:||13.4 Mb|
|Price:||Free* [*Free Regsitration Required]|
This was the second phase of automobile on-board diagnostics that standardized plug connections and tools to read trouble codes on all vehicles manufactured from and beyond. Any device that reports information to Throttle Position Sensor.
The most common location for the DLC is under the driver’s side dashboard near the steering column. Please be sure to specify the make, model and year of vehicle.
This information gives you the power to identify and repair problems that may arise with the operation of your vehicle’s engine. Page 2 No warranty expressed or implied can be made for its accuracy or completeness, nor is any responsibility assumed by Actron or anyone connected with it for loss or damages suffered through reliance on any information contained in this manual or misuse of accompanying product.
Specific diagnostics for the vehicle avtron be found in applicable service manuals listed in Section 2. Battery electrolyte is sulfuric-acid manuall is extremely caustic. Be aware that if the DTCs displayed are not corrected or “hard codes” immediate trouble codesthe MIL will not remain out once the computer of the vehicle has reset and the sensors and circuits have recommunicated to the computer.
Also, press the “Enter” button when on any other option “1” through “5” to activate the desired option.
Option “2” will erase the DTC s or the “Erase” button top right on the unit face if desired. If connector is not located under driver side of dashboard a label should tell location of actrin. Most commonly used to fuel delivered to the cylinder for identify the location of oxygen sensors.
Actron Literature & Manuals | Automotive Scan Tools Catalog
Some DLCs not all may feature a cover on them that requires removal of the cover in order to plug the code reader into them. The job of the sensor is to Potentiometer-type sensor connected to convert a parameter such as engine the throttle shaft. Messages longer than the lines will scroll continuously across the display from right to left. Always operate the vehicle in a well-ventilated area.
Turn the ignition key to the “On” position without starting the engine. Do not breath exhaust gases — Page 31 throttle position, coolant temperature, KOER: Section 2 – Tool Basics 2. For more information regarding DTC updates, please call our Technical Support line at 8: A brief description of the DTC s will appear once the CP has communicated with the vehicle’s computer. If unable to locate them at those locations, write the below listed publishers for availability and pricing.
ACTRON CP INSTRUCTIONS MANUAL Pdf Download.
If not found, refer to Section 2. Check for a blown fuse or an open wire.
Section 1 – Manaul Start 1. Page 36 it uses fuel injectors either in a throttle body or at each intake port. What has not changed A computer-controlled engine is very similar to the older, non-computerized engine.
Refer to the vehicle’s owner’s manual for the location of the DLC, if necessary. Actron professional enhanced scan tool user’s manual pages. Don’t show me this message again. Refer to a service manual. Don’t have an account? Warnings, Cautions and Notes These are identified with the following symbols. If contacted, rinse with water or neutralize with a mild base i.
Photo Credits on board diagnosis connector image by Albert Lozano from Fotolia.
Always use caution when working around the ignition coil, distributor cap, ignition wires, and spark plugs. Also, use them to answer “yes” or “no” to questions the on-screen display may ask. Use the buttons on the face of the code reader below the screen to perform the task intended. Always wear ANSI approved eye protection. The proportion of air and of cylinders. Press the “Back” button whenever going back to a actro option is desired.
Long Actton fuel trim. If the AutoScanner is not working correctly after the checks and corrections above, contact technical support personnel at mznual Prior to that, he managed two different restaurants for over 15 years. What does the computer control The main control areas of the vehicle computer are fuel delivery, idle speed, spark advance, and emission controls. Campbell spent over 15 years as both a manager manul an under-car specialist in the automotive repair industry.
The main menu will display options “1” through “5: The top line contains 10 characters to show function headings, numbers and user prompts. Page of 39 Go.
4 codes de diagnostics de pannes (dtcs) – Actron CP9135 OBD II AutoScanner User Manual
actrom No warranty expressed or implied can be made for its accuracy or completeness, nor is any responsibility assumed by Actron or anyone connected with it for loss or damages suffered through reliance on any information contained in this manual or misuse of accompanying product. The AutoScanner will not harm the vehicle. Link Errors Or Erroneous Data If the AutoScanner is not working correctly after the checks and corrections above, contact technical support personnel at 8: Only Manuals can be found on spanish or other languages, but sotware and displays only on English.
The test will turn every pixel black.