General This European Standard applies to water-tube boilers with volumes in excess of two litres for the generation of steam and/or hot water at a maximum . INTERNATIONAL. STANDARD. ISO. Second edition. Textiles — Assessment of the ignitability of bedding items —. Part 1: Ignition source. First edition. Textiles — Burning behaviour of bedding items —. Part 1: General test methods for the ignitability by a smouldering cigarette.
|Published (Last):||8 November 2007|
|PDF File Size:||8.74 Mb|
|ePub File Size:||8.31 Mb|
|Price:||Free* [*Free Regsitration Required]|
Leave the ignition source in position for 15 s, then remove it from the test eh. Standard Textiles — 129952-1 of the ignitability of bedding items — Part 1: Introduzione I corsi di formazione Calendario Archivio corsi. At least 2 original edges per specimen.
A specific test method for bedding items, which can normally be placed on a mattress, for example: It is also not allowed to have any occurrence of flames initiated by the smouldering cigarette. Observe the specimen for any evidence of progressive smouldering ignition or flaming ignition.
BS EN 12952-1:2015
Ignition sources are applied on flat surfaces, quilts, edge tapes, underneath quilts, between sheets, etc. Short test description The tests are performed in a test cabinet with a calibrated air flow. 122952-1 pubblica preliminare UNI: The requirements of this European Standard take account of pressure-related hazards, which apply to water tube boilers, including failure of pressure-retaining components due to overheating.
This aim will be achieved by: The bedding item must not smoulder or produce externally detectable amounts of smoke, heat or glowing 12925-1 15 minutes following the removal of the ignition source.
BS EN ISO – Flame Retardants
According to the standard for railway applications, ENbedding items are to be tested according to EN ISOignition with a match flame equivalent. The test assembly is subjected to a gas flame for 15 seconds.
No flaming is allowed to continue for more than seconds after removal of ignition source, and the specimen must not burn until it is consumed within the test duration. This standard recognizes that it is not possible to cover all the combinations of situations that might arise. General test methods for the ignitability by a smouldering cigarette.
Information about EN ISO 12952-1:2010 and EN ISO 12952-2:2010
The test specimen is located on a substrate of mineral wool, on top of a steel rig. If flaming ignition of the test specimen is not observed, repeat the test at a fresh position. If progressive smouldering ignition is not observed, record non-ignition unless the test specimen fails the final examination.
Textiles — Assessment of the ignitability of bedding items 12925-1 Part 2: These test methods only evaluates the ignitability of bedding products and does not evaluate the burning behavior of a specific item. Place the ignition source in enn prescribed position.
Politica europea sulla normazione Normazione e professioni non regolamentate. Record the extent of damage. Light the propane emerging from the burner tube, adjust the gas flow to the rate and allow the flow to stabilize for at least s.
BS EN – Water-tube boilers and auxiliary installations. General
The following equipment and components can be integrated in the assembly 12952- the discretion of the manufacturer: Carrello UNIstore Non ci sono articoli nel tuo carrello. Unless large parts of the specimen are consumed by the test, repeat tests can be carried out on the same specimen. Leggere attentamente le istruzioni prima di effettuare il download.
Materials that can be tested according to this standard Mattress covers, underlays, incontinence sheets and pads, sheets, blankets, electric blankets, quilts duvets and covers, pillows whatever the filling and bolsters, pillowcases. Water-tube boilers and auxiliary installations – Part 1: Why test according to this standard?
If progressive smouldering or flaming ignition of the test specimen is observed, extinguish the test specimen, note the time the test was stopped and the reason, record that ignition had occurred and discontinue testing.
During the cigarette test the bedding item is not allowed to smoulder or produce externally detectable amounts of smoke, heat or glowing after one hour from the beginning of the test. Specific test methods for the ignitability by a small open flame. In this case, extinguish the test specimen and record that ignition has occurred. If flaming ignition is not observed in the repeat 129521, continue to observe both test sites for evidence of progressive smouldering ignition.
Textiles – Burning behaviour of bedding items — Part 3: General test methods for the ignitability by a small open flame. If progressive smouldering ignition or flaming ignition is observed in this repeat test, extinguish the test specimen, note the time the test was stopped and the reason, and record that ignition had occurred for the ignition source used.
This standard does not apply to mattresses, bed-bases and mattress pads. The purpose of this European Standard is to ensure that the necessary essential safety requirements according to Annex I of the Pressure Equipment Directive are fulfilled in order to guarantee the safety of water tube boilers. The standard is used to assess the ignitability of bedding items when subjected to a smouldering cigarette and a match flame equivalent as ignition source. Data entrata in vigore: