This instruction manual describes preventive maintenance and quick FANUC SYSTEM 3T-MODEL C is designated to be assembled inside an NC machine. Fanuc System 3T-Model D Operator’s Manual(BE 02) – Free download as PDF File .pdf) or read online for free. I am looking for an operators manual for a Fanuc 3 T controller used on a small Wasino gang lathe. Any help would be appreciated. Going to.
|Published (Last):||13 February 2011|
|PDF File Size:||8.40 Mb|
|ePub File Size:||9.11 Mb|
|Price:||Free* [*Free Regsitration Required]|
Mostly I took everything that I could unbolt apart and sandblasted it, did have to fix the turcite on one of the ways.
So if the table moves 1″, the readout said 2″. This is probably exposing my maunal, but gridshift is the only thing I can find that references the machine absolute zero.
What did they use originally? A PM conversation with memoryman is giving me hope. Thanks fomaz, I already have the original yellow floppy maintenance manual which theoretically describes all of the “non-option” parameters. From his recollection, the 3T normally has 20m 8KB of memory and is expandable to 40m onboard, up to 80m with additional memory cards. Let me know if there’s anything I can do to help you with your unit! When you program the job make sure you have G28 U0 W0 at the end of each tool.
Results 1 to 12 of Anybody know if thats an option you can add afterwards? Last edited by fordav11; at For anyone else in the future who has the same question, I took fordav11’s solution and implemented it like this. Now I just need to figure out if there’s any way to set DNC on this machine MINP isn’t defined anywhere in the maintennace manual or the electrical manual.
Is there are process to set either the work offset or tool offset as relative to the absolute zero instead of the “random” zero?
Fanuc 3T Parameters Manual pdf – CNC Manual
Anybody has any idea what that means? Originally Posted by fordav I have a Fanuc 3T Maintenance manual but nothing Tsugami specific, Fanuc referred me to Tsugami, and those guys told me to talk to Remington Sales who disavowed all knowledge of this unit.
I cannot help you about that model, but I am almost sure that there will be a parameter that will set the coordinates as you wish for the homing.
Then I went on to the drive and the Igbat’s. I have a RS set up from onother post printed and I will ganuc for the post and forward Email ktaylor earthlink. I’m very familiar with machining centers, but I’m in need of some assistance translating that into “ancient” CNC lathe operation.
Cold and snow now so inside work will maybe get cought up Good luck Kevin. Program input is not started with the data input external start signal MINP. Thanks fordav11, that worked! Didn’t realize that featurecam defaults to using its own radius compensation in addition to the radius compensation in the tool offsets so the part came out a hair oversize. fanuf
Fanuc 3T Parameters Manual
The time now is There are integers, not bits, so they are easy to identify. Posted via Mobile Device.
Let me know if I can help with what documation I have. So here’s some before pictures. Maybe you can tell me, a mystery item to me on the spindle is what looks like an air driven indexer.
Fanuc 3t Maintenance Manual
I haven’t found any hardware manual for the PL3B’s, they’re kind of an orphan product. In any event, it seems to be new enough to support tool offsets. Did you do a number on the DC servo’s? manul